Another Mill Upgrade (with a Plot Twist)

[singlepic id=295 w=320 h=240 float=left]Some time last year, I found this link and went as far as getting in touch with Harbor Freight to try to order the telescopic metal way cover from the Sieg KX3 CNC machine. I dropped the project once I learned it would take months and cost a lot.

Last week I noticed that LMS was now carrying the cover, and I decided that would be a nice (if a bit pricy) upgrade to protect the dovetails and ballscrew of the Y axis. It wasn’t really any cheaper than dealing with Harbor Freight, but at least I know LMS had them in stock and it wouldn’t get lost on a boat in the ocean somewhere.

Fast forward through an evening of installing it on my machine, complete with lots of angle grinder action to fix the questionable fit in a few spots. I was wrapping up in the shop for the evening when I discovered (the gentle way, thankfully, not via a rapid crash) that the ProMiCA kit and the way cover interfere with one another!

The ProMiCA kit is clever and tucks the motor for the X axis behind the table; unfortunately, that’s the exact spot that’s taken up now by the telescopic way cover when X is as its minimum travel. I guess my only real choice at this point, if I want to keep the way cover, is to flip the motor around and rework a cover for the belt drive. That is going to add quite a bit of length on that axis, especially considering I’m planning to put a long table on the mill.  I’ll have to think about this a bit – keep the way cover, or sell it?

I also discovered that the way cover, which is really intended for a machine with a taper gib arrangement (and thus no grub screws on the right hand side of the dovetail), doesn’t quite provide perfect protection of the ways on the X3.  I tried an experiment creating a stepped cardboard guard that would sit along side the axis and help block chips from bouncing in or floating in on flood coolant.

[nggallery id=34]

Related Posts

Project Frankenmill – Part 33, Claustrophobia

Final positions for the DIN rails and wire management have been nailed down. It’s much more tight than one should really wire a panel like this, but…

Project Frankenmill – Part 32, You’re Gonna Need a Bigger Boat

It seems to be a rule that no matter what size electronics enclosure you have, you will always have at least 10% more stuff that you need…

Project Frankenmill – Part 31, Full Pull

While I still haven’t gotten into the detail of squaring and tramming, I’ve been intensely curious to see if the new Z axis would be happier with…

Project Frankenmill – Alpha and Omega

Since 2009, I’ve been messing around with CNC machines. I started out with a small manual milling machine from Grizzly, and converted it to CNC using a…

Project Frankenmill – Part 30, Do You Even Lift Bro?

Hauled the column back down to the shop and mounted it back on the machine. Sure is a lot heavier than it used to be! Muscling things…

Project Frankenmill – Part 29, More Machining and Motion

Had some productive time in the shop during the holiday. First step was to make the counterbores for the M6 cap screws a bit deeper. Easy to…

This Post Has 3 Comments

  1. Hi, I need one like this for my SX3. Do you make them for sale? If yes, how much you sale them for?

    Thanks in advance!

    Carlos

Leave a Reply

Your email address will not be published. Required fields are marked *